Christie Roadster 14K-HD

Christie Roadster 14K-HD

POWER ON/ POWER OFF PROJECTOR

POWER ON
1. Connect power; turn main power switch to "on" position
2. Wait for projector to initialize (about a minute)
3. When the LED screen indicates the projector is ready, press and hold the power button on the remote control to turn on lamps (takes a minute for them to warm up)

POWER OFF
1. Press the power button on the remote control; press a second time to confirm power down. Projector will enter standby mode
2. Wait FIVE MINUTES for the lamps to cool down. DO NOT TURN OFF POWER UNTIL COOL-DOWN IS COMPLETE
3. When projector indicates cool down is complete, turn off main power switch or disconnect the projector from the power supply
NEVER ATTEMPT TO RE-START THE LAMPS WHILE PROJECTOR IS IN COOL-DOWN MODE


PIPE MOUNT

Mount projector to Peerless-AV Heavy Duty Universal Projector Mount - PJR125

1. Remove projector, power cable and remote control from road case
2. Replace road case cover and set projector on top, upside down. Position road case directly under the pipe from which projector will be hung
3. Screw in the eye bolt to the "Safety" screw hole in he center bottom of the projector
4. Attach safety cable to the eye bolt (run the looped end through eye bolt and then loop the carabiner end through the loop)
5. Align projector mount arms with the mounting screw holes (minimum four connecting points, six are available)
6. Use 4-6 bolts (M8) with washers and spacers if needed to attach the projector mount arms to the projector
7. Run safety cable, power cable and video feed through the center tube and up through the top of the projector mount
8. Use two U-brackets to attach the projector mount to the pipe
9. Loop safety cable around pipe and secure with carabiner
10. Secure power cable and video feed to the pipe with zip ties
11. Set the main projector power switch to the "on" position
12. Install projector lens
13. Power on the projector and test the video signal
14. Raise pipe to desired height
15. Use pitch and yaw adjustments on projector mount along with lens shift functions on the projector to position the projected image
16. Firmly tighten all screws and bolts to lock the projector position in place


SET PROJECTED IMAGE FOR UPRIGHT OR INVERTED INSTALLATION

1. MENU
2. CONFIGURATION
3. OUTPUT SETTINGS
4. L/R Arrows to cycle through the options
5. Click MENU to escape




    • Related Articles

    • Driving Projected Theatrical Sets

      Ion offers a number of projected sets that can be driven with Muséik. There are a few unique aspects to a projected set that should be considered. PRE-PRODUCTION PROJECTION SURFACE In many cases a back wall cyc curtain will work very well. This setup ...

    • Using A Video Wall Controller to Project on Multiple Surfaces

      This article will discuss how to produce a multi-panel video projection using the Matrox QuadHead2Go video wall controller. INTRODUCTION Premiere of Julie Giroux' "Blue Marble" Using a 3 Panel Video Installation It is possible to project visuals on ...

    • Sound not coming through HDMI connection

      Video and audio signals are treated entirely separately in Muséik. Audio signals are not sent out with the video signal. For that reason you will not get an audio signal through an HDMI connection. All audio is sent out through either the computer ...